
Vintage Pro Owners Manual 17
Setup
Connection Instructions
If you insert a stereo plug into one of the Sub Outputs, the ring of the plug
serves as a signal Return which sums into the Main outputs.
Therefore, the Sub 1 and Sub 2 jacks can serve as effect sends and
returns in order to further process selected instruments and then
return them to the main mix.
You can use the Sub 1 and Sub 2 jacks as send/returns in order to further
process selected Vintage Pro presets without using the effects bus on the
mixing board. In a pinch, the effect returns can be used to sum additional
instruments into the main outputs. It’s like having an extra line mixer
when you need more inputs!
You can use the Sub 1 and Sub 2 jacks as effect returns to the Main Outputs.
Note that the Effects Processors are only routed to the Main Outputs.
Power Up! The power switch is located on the right side of the front panel. You can
turn on the Vintage Pro and its MIDI controller in any order. When power
is applied the liquid crystal display will light, indicating that Vintage Pro is
operating. You may have noticed that there is no 110/220 Volt power
selector switch on Vintage Pro.
Vintage Pro automatically switches itself to the proper
line voltage.
MAINS
RL
R Bus
L Bus
Output Section
Tip
Ring
Tip
Ring
SUB 1
RL
Tip
Ring
Tip
Ring
SUB 2
RL
Effects
Processors
Comentários a estes Manuais